Installing a Brick Paver Walkway or Single Bricks

The use of Bricks or Pavers to produce a pathway or outdoor patio complements a home in a way that is unmatched. In addition, setting up a Brick or Paver walkway does not always require a pro.

The secret to setting up a Brick or Paver Walkway is to first properly prepare the location where the bricks/pavers are to be installed. In addition, string lines should be strung on each side of the sidewalk.
When the area has actually been dug down, 3/4" gravel stone need to be laid in and tamped down firmly. Then 2" of sand, or stone dust must be topped the gravel. Once again the sand/stone dust ought to be tamped down. Stone dust is chosen. The height between the tamped down sand and the stringline need to equal the density of the brick or paver.

Now that you have a stable base, put a 1" pipeline or ledger board the length of the pathway on either side of the walkway. Using a flatedge, e.g. a 2"x4" board, slide it over the two lengths of the pipe/ledger board. In doing this you will create a level area to lay the bricks/pavers.

Now put on the level sand/stone dust strips of plastic brick borders. Set up a run on both sides of the prepared area. These strips will serve as your sidewalk border and help to maintain the integrity and shape of the sidewalk. You can get these plastic strip borders at most home enhancement shops. The strips need to be anchored down with 12" galvinized nails. You should sink these nails into the ground and through the strips every foot.

You can then begin to lay the bricks/pavers once this is done. There are lots of patterns you can lay. I particularly like the Herring Bone pattern. here The key to laying the bricks/pavers is to guarantee that they interlock with each other. Constantly stagger nearby rows of bricks by 1/2 of a brick to interlock them. This will again assist preserve the integrity of the walkway.

Inevitably bricks/pavers will require to be cut or split when developing the sidewalk. Unless you desire to purchase or lease an expensive wetsaw, I would recommend purchasing a simple brick/paver splitter. It is essentially a chisel with a broad end that is the width of the bricks/pavers. To in fact cut/split the brick/paver, lay it in a bed of sand and place the sculpt at a 75 degree angle over the area where you desire to break the brick. Utilizing a hammer strike the butt end of the sculpt firmly. You may need to do this a number of times. You may likewise wish to flip the brick/paver over and strike the opposite of the brick utilizing the hammer and chisle. Within one or two strikes the brick/paver need to break cleanly. If your walkway has curves you will require to buy/rent a wetsaw.

After setting up the bricks, build up the outdoors edges with additional sand, and then shovel in the topsoil and load down securely.
Spread stone dust over the new pathway and sweep into the fractures. This will complete the interlocking of the bricks and assist to eliminate any weed growth.


In addition, installing a Brick or Paver walkway does not necessarily require a pro. The key to installing a Brick or Paver Walkway is to first effectively prepare the location where the bricks/pavers are to be installed. Now that you have a stable base, put a 1" pipe or ledger board the length of the walkway on either side of the walkway. These strips will act as your sidewalk border and help to preserve the stability and shape of the sidewalk. here Undoubtedly bricks/pavers will require to be cut or divided when building the pathway.

Leave a Reply

Your email address will not be published. Required fields are marked *